No products in the cart.
How often should I retighten the screws?
After installation, check and tighten all screws on a Globlazer cat tree. Then, 2 to 3 days later, check again to ensure that the screws are properly tightened. Check the firmness of all the screws at least once a month. Use the hex key from the hardware bag. The manual does not give torque numbers or an assembly-time estimate.
Updated 2 September 2026. Written by Globlazer Assembly Support.
Fits / Not Fits
| Fits | Not Fits |
|---|---|
| The three-step check schedule from Manual Notes | Nm torque specs, or how many minutes assembly should take |
| Monthly firmness checks | Rewriting the full safety chapter from the pillar page |
Source: official Globlazer assembly manual, Notes on screw checks.
| When | What |
|---|---|
| Immediately after assembly | Check and tighten all screws |
| 2 to 3 days later | Check again and tighten |
| At least once a month | Check firmness of all screws |
Quick checks
- Walk the whole tree and check every screw the parts list uses.
- Keep the hex key with the tree so monthly checks are not skipped.
- If a joint still moves after you tighten to the drawing, confirm the part codes match before adding force.
Next steps
- How to assemble a cat tree — full method, including this schedule in context
